Q. What
are the prices?
A.
You can find our pricing HERE
Q.
How much is shipping?
A.
For the 2 oz sampler, it is $2.00 and for the ½lb kit, it is $5.00
For other sizes, please email me.
Q.
How can I pay?
A.
I take PayPal (preferred), Money Orders and checks. Checks will be
held until they clear the bank, which is usually 7 days. Email me
to obtain a
mailing address for sending payments through the mail.
Q.
Where do I send PayPal payments?
A.
You can send order payments to our PayPal account at: orders@puffinalia.com
Alternatively, I can PayPal invoice you. Please email me to discuss.
Q.
Do you take credit card payments?
A.
Not at this point in time, except through PayPal.
Q.
Do you ship internationally?
A.
Yes I do. Shipping will be higher, however, to ship to other countries.
Please write us to ask specifics.
Q.
What is the shelf-life of Miracle MoldTM?
A.
We have been informed by the chemist that the shelf-life of
this product is "at least a year." Since we package the material
in airtight jars,
it may be even longer than that.
Q.
What is the library life of Miracle MoldTM
molds?
A.
Molds made from Miracle MoldTM
should last indefinitely without degradation!
Q.
I was wearing rubber gloves and the Miracle Mold stuck to it.
A.
We recently found out that this indeed latex gloves are incompatible with
Miracle MoldTM
This information will be added to our information sheet in the very near
future.
Q.
A portion of my mold from a rubberstamp didn't set up. Why?
A.
Although Miracle MoldTM
works with just about every master material, there is a specific
exception to the rule, and that is TIN. There is a chemical
reaction between items
containing tin and Miracle MoldTM.
Not all stamps contain tin, but many do. It is suggested
that if you are in doubt about the properties of your stamp, try a SMALL
section first.
If you don't get a good moldset, you can probably assume there is tin in
the rubber. One
work-around is to use a barrier like SaranWrapTM
between the stamp and the mold.
You can also often set a mold by heating it in the oven for a few minutes.
Also please remember that when working with rubberstamps, as well
as with any
other artwork, that you may be working with copyrighted designs.
Please be aware, fair and legal with your moldmaking.
Q.
What if my mold doesn't set up?
A.
It is very unusual for a mold to not set up, but if you run into that situation,
try using
less catalyst (red part). You can also set a mold by heating it in
the oven for a few minutes.
Q.
How many molds does a 1/2 lb kit yield?
A.
Based on weighing one of my molds of a coat button on a gram scale, it
appears
that a 1/2 lb kit will make approximately 32 molds. Your results
may vary.
Q.
Can I find Miracle MoldTM
in stores?
A.
Not at this point in time. Puffinalia is the sole current distributor
of Miracle MoldTM
Please email
us if you have further questions. Thank you!